JFrodsham
About
- Username
- JFrodsham
- Joined
- Visits
- 28
- Last Active
- Roles
- Member
- Points
- 6
- Badges
- 0
Comments
-
So just to make sure... when there is no r1 file, like in "logi-projects\logi-wishbone\hw\logibone\hdl", use the ra3 file? Thanks, Justin
-
Ok, Using the August build everything looks good. I did some testing though, and it does not seem like I need sudo to load a bit file. I completely powered down and rebooted to make sure, and sure enough it loaded the bit file fine. That will …
-
"do you run the logi_loader command as sudo ?" I did not. If it boils down to that I will need a vacation. Also trying the August build right now too. -J
-
I see I am not the only who ran into the mysterious not working on first build. -Justin
-
Ok... nevermind. Twilight zone. Both work now. -Justin
-
@ I will try my local one again. -Justin
-
It appears you have been tightening up the image, leaving the wiki a bit behind : pi@raspberrypi ~ $ sudo apt-get install gcc make git Reading package lists... Done Building dependency tree Reading state information... Done gcc is already t…
-
By that i just meant... the silk screen and wiki imply the switches are for me ... The tape made me nervous as I saw that as "Don't change these switches or bad things will happen". Thanks, Justin
-
Received! I got the full package (Edu/Cam/Bone/Pi). One thing I noticed..... seems built in Shenzen (20 min from Hong Kong), but then shipped to Singapore... and then shipped to US. My wife was literally minutes away from just picking it up in pe…
-
I can give you a good example of why you might want to use the SPI flash. You can get the FPGA up and running in milliseconds. We were running a Microblaze with a Linux kernel and the FPGA could perform its functions autonomously once Linux booted…
-
This looks MUCH better: June 25, 2014 , 5:51 pm Processed through USPS Sort Facility JAMAICA, NY 11430 Soon! -J
-
I sure hope this is wrong... status just changed to "Origin Post is Preparing Shipment". -J