ouattfred
About
- Username
- ouattfred
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
- Badges
- 0
Comments
-
I tried but I had some troubles. I finally used serial pins. thank!
-
I have the R1.5 revision board. so the logipi v2 i suppose. Can i use the i2c pins as standard GPIO? (i mean like input from fpga to RPI)
-
Hi, I would be grateful if you could tell me how many GPIO can be used with the Loipi. Is it just GPIO GEN2 and GPIO GCLK? thank!
-
Sorry it's work now. I just reboot my RPI and when i try it works very well. Thank you very much for your help.
-
Thank you for your prompt response. When i did your request i had the following message. Compiled for LOGI-PI could not open I2C device : /dev/i2c-1! Cannot detect LOGI-PI with I2C_LOADER, switching to old bit-bang loader Board variant is LOGIPI…
-
Yes i just downloaded in git repository the logi-tools-master folder and i ran the script install_logipi.sh in the same folder. In the unified_loader folder when i ran the two commands i had the following message as you can see in the attach image.
-
In fact i have two logi pi and rasberry pi B. In the first board i am using a pre-configured image downloaded on your website (http://valentfx.com/doc/logi-image/) and i did not install anything else. When i run the make_demo.sh in the logi-a…
-
Good morning! I have a same issue but i use the logipi R1.5.1 with a raspberry pi B (not a RPI B+). I followed the instructions above but when i run the command sudo make install i get the following message make: Warning: File 'Makefile' has…